What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 04:51

These are simplified answers to the original question, and does not change anything I wrote above.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One is “what exactly is in a ‘surge protector’ ? ”
An AC voltage/ current source, and an ac inductive load.
What is lightning?
a photo is worth a thousand words.
Why is only the left side of my vagina bleeding, on and off?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This device then solves the entire problem.
Because the load is inductive, the current lags the voltage.(by a bit).
These devices are installed between the “hot” and “neutral” and protective ground.
(Dc diagram shown, AC is similar).
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Belmont Stakes: Hill Road faces challenges beyond tough field - Horse Racing Nation
What does a fuse do?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Barnstars:
What is a common thought that keeps people up at night? Why do some people experience this?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
The other is “what does a “fuse” do?”
One
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
but I think this circuit , shows a few more pieces.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Scientists Uncover Giant Spiders That Once Terrorized Jurassic Earth - The Daily Galaxy
This is 'the assistant's answer'
Here is a simplified AC power diagram.
There are two important concepts here.
In schematic diagrams this is the symbol for a fuse:
Now when you have a certain ac resistance, then a current flows in a loop.
eight
The third is lightning and “how it gets conducted into a home.”
At one ohm, the resistor has a maximum of 1 watt power.
He then describes Rainy Season and Lightning.
Upcoming Telescope Predicted to Discover Millions of Hidden Solar System Objects - Gizmodo
[old diagram got deleted by accident]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The bolt then partially travels down the line to your home.
What is Opec+ up to? - Financial Times
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are three different concepts here that are getting confused.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
what exactly is a ‘surge’ protector?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–14 [Omar Gharbi Omar Gharbi ]
but this device (an Inductor) … impedes the rapid changes in the current.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Upvotes:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–16 [ OO OLAOYE OYEBODE ]
He then asserts :
But… the neutral is now “floating” because of the 1 ohm resistance.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This one hit behind the barn.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
the problem then depends on "how fast does the fuse operate?".
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–10[John johnson John Johnson ]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
At least they know the answer if they wanted it.
This is where the MOV conducts again, and dissipated the energy.
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
nine
But it can get overloaded, and no longer works.
A fuse is a non-resetable over current circuit protector.
Edit 2024–10.
It also is a device that limits the change in current flow.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The MOV will conduct when the voltage exceeds 50% of line voltage.
so, what happens?
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
He then describes the function of a fuse.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
A circuit breaker is similar, but is resettable.
For this case there are devices called Metal oxide varistors (MOV).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
First Sentence:
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
[image of Common-mode choke]